Annexes to COM(2003)145 - Passenger hand-holds on two-wheel motor vehicles (Codified Version) - Main contents
Please note
This page contains a limited version of this dossier in the EU Monitor.
dossier | COM(2003)145 - Passenger hand-holds on two-wheel motor vehicles (Codified Version). |
---|---|
document | COM(2003)145 |
date | July 13, 2009 |
(5) OJ L 124, 9.5.2002, p. 1.
ANNEX I
1. GENERAL REQUIREMENTS
Where provision is made for carriage of a passenger, the vehicle must be fitted with a passenger hand-hold system, which must take the form of a strap or a hand-grip or hand-grips.
1.1. Strap
The strap must be fitted to the seat or to other parts connected to the frame in such a way that it may easily be used by the passenger. The strap and its attachment must be designed in such a way that they withstand, without snapping, a vertical traction force of 2 000 N applied statically to the centre of the surface of the strap at a maximum pressure of 2 Mpa.
1.2. Hand-grip
If a hand-grip is used it must be close to the saddle and symmetrical to the median longitudinal plane of the vehicle.
This hand-grip must be designed in such a way that it is able to withstand, without snapping, a vertical traction force of 2 000 N applied statically to the centre of the surface of the hand-grip at a maximum pressure of 2 MPa.
If two hand-grips are used they must be fitted one on each side in a symmetrical manner.
These hand-grips must be designed in such a way that each is able to withstand, without snapping, a vertical traction force of 1 000 N applied statically to the centre of the surface of the hand-grip at a maximum pressure of 1 MPa.
Appendix 1
Information document in respect of passenger hand-holds for a type of two-wheel motor vehicle
(to be attached to the application for EC component type-approval if this is submitted separately from the application for EC vehicle type-approval)
Order No (assigned by the applicant): …
The application for EC component type-approval in respect of passenger hand-holds for a two-wheel motor vehicle must contain the information set out under the following points in Annex II to Directive 2002/24/EC:
— | Part 1, Section A, points:
|
— | Part 1, Section B, points:
|
Appendix 2
Name of administration
EC Component type-approval certificate in respect of restraint devices for passengers for a type of two-wheel motor vehicle
MODEL
Report No … by technical service … date …
EC Component type-approval No: … Extension No: …
1. | Trade mark or name of vehicle: … |
2. | Type of vehicle: … |
3. | Name and address of manufacturer: … … |
4. | Name and address of manufacturer’s representative (if any): … … |
5. | Date vehicle submitted for test: … |
6. | EC Component type-approval granted/refused (1) |
7. | Place: … |
8. | Date: … |
9. | Signature: … |
(1) Delete as appropriate.
ANNEX II
PART A
Repealed Directive with its amendment
(referred to in Article 5)
Council Directive 93/32/EEC | (OJ L 188, 29.7.1993, p. 28). |
Commission Directive 1999/24/EC | (OJ L 104, 21.4.1999, p. 16). |
PART B
List of the time-limits for transposition into national law and application
(referred to in Article 5)
Directive | Time-limit for transposition | Date of application |
93/32/EEC | 14 December 1994 | 14 June 1995 (1) |
1999/24/EC | 31 December 1999 | 1 January 2000 (2) |
(1) In conformity with the third subparagraph of Article 4(1) of Directive 93/32/EEC:
‘From the date mentioned in the first subparagraph Member States may not, for reasons connected with the passenger hand-holds, prohibit the initial entry into service of vehicles which conform to this Directive.’
The said date is 14 December 1994; see the first subparagraph of Article 4(1) of Directive 93/32/EEC.
(2) In conformity with Article 2 of Directive 1999/24/EC:
‘1. With effect from 1 January 2000, Member States shall not, on grounds relating to passenger hand-holds:
— | refuse, in respect of a type of two-wheel vehicle or a type of passenger hand-hold, to grant EC type-approval, |
— | prohibit the registration, sale or entry into service of two-wheel motor vehicles or the sale or entry into service of passenger hand-holds, |
if the passenger hand-holds comply with the requirements of Council Directive 93/32/EEC, as amended by this Directive.
2. With effect from 1 July 2000, Member States shall refuse to grant EC type-approval for any type of two-wheel motor vehicle on grounds relating to passenger hand-holds or any type of passenger handhold, if the requirements of Directive 93/32/EEC, as amended by this Directive, are not fulfilled.’
ANNEX III
Correlation table
Directive 93/32/EEC | Directive 1999/24/EC | This Directive |
Articles 1, 2 and 3 | Articles 1, 2 and 3 | |
Article 4(1) | — | |
Article 2(1) | Article 4(1) | |
Article 2(2) | Article 4(2) | |
Article 4(2) | Article 4(3) | |
— | Article 5 | |
— | Article 6 | |
Article 5 | Article 7 | |
Annex | Annex I | |
Appendix 1 | Appendix 1 | |
Appendix 2 | Appendix 2 | |
— | Annex II | |
— | Annex III |